Heat Shrink Boots Lipped 90° Right Angled

Heat Shrink Boots Lipped Right Angled

Available in: Available in eight sizes, 90° and 45°angle boots fit adapters from .350"(8.89) to 2.550" (64.80) diameter.

Type 1 High-Performance Elastomer Boots for Advanced Temperature and Chemical Tolerance

DTL-HSB-001A1 (With Eyelet)

DTL-HSB-003A1 (Without Eyelet)

Semi-rigid high performance boots combine excellent resistance to fuels, oils and solvents withsuperior performance at extreme temperatures. Rated for 3000 hours continuous operation at+150° C, these boots fit most standard boot adapters for circular connectors. Material meets therequirements of VG95343 Type 6, BSG 198-5-DE, EN62329-102 and SAE AS5258 Type H. These boots are recommended for demanding applications such as military vehicles and petrochemical exploration. Boots come standard in black, see table below for optional colors.

Available in ten sizes, standard boots fit adapters from .250" (6.35) to 2.470"(62.70) diameter.

Type 2 Low Smoke Zero Halogen (LSZH) For Regulated Environmental Safety Applications

DTL-HSB-001A2 (With Eyelet)

DTL-HSB-003A2 (Without Eyelet)

Halogen-free polyolefin boots meet low smoke and toxicity requirements of shipboard, transit and aircraft systems. These Low Smoke/Zero Halogen (LSZH) boots fit most standard shrink boot adapters, including M85049 adapters. Oxygen index greater than 30%, smoke index less than 20, and toxicity index under 3 per 100 grams. Material meets requirements of NAVSEA 5617649, VG95343 Part 29, BSG 198-5-DF, EN62329-101 and SAEAS5258 Type G. Good resistance to oils, fuels and solvents. Available high temperature hot melt adhesive lining, these boots provide strain relief and environmental protection to connector/cable transitions. Temperature rating -30° to +135° C. Black colour.

Type 3 Flexible Polyolefin For General Duty Applications

DTL-HSB-001A3 (With Eyelet)

DTL-HSB-003A3 (Without Eyelet)

Economical flexible polyolefin boots fit most standard shrink boot adapters, including M85049 adapters. These self-extinguishing boots meet the requirements of SAE AS81765/1 Type 1. Good resistance to oils and fuels. Available with optional hot melt adhesive lining, these boots provide strain relief and environmental protection to connector/cable transitions, and are ideally suited for heat-sensitive cables due to the material's low heat shrink temperature of +100° C. Temperature rating -55° to +135° C. Black colour.

Pre-coated AdhesiveType  “R” for Type 1,2 & 5 material boots.

Type “R” is a high performance pre-coated epoxy adhesive. The adhesive meets required specification levels of AS 5258 and VG 95343 part 18. The adhesive is capable of withstanding high stresses between -75°C and 150°C and prolonged high temperature immersion in fuels and oils. Peel adhesion is very high to a wide range of materials used to manufacture connectors or backshells including aluminium with various types of plating as well as plated and unplated composite thermoplastics. Type “R” can be used on most cable jacket materials including fluorocarbon rubbers, although fluropolymers such as ETFE and PVDF require surface treatment.